
Licensed commercial HVAC pros for offices, retail, and restaurants across all five boroughs
Commercial air conditioning services new york NY that keep your business running
When your commercial air conditioning services new york NY system quits in July, you do not need a sales pitch - you need cold air and an invoice that makes sense. We repair, install, and maintain rooftop units, split systems, and VRF equipment for offices, restaurants, retail shops, and warehouses across Manhattan, Brooklyn, Queens, and the Bronx. Same-day commercial AC repair new york NY is available when your space hits 85 degrees and your staff is sweating.
What's included
What our commercial AC service includes
Every commercial air conditioning services new york NY call includes a full diagnosis, a written price before work begins, and a test of the system before we leave. Here is what is covered on a standard repair or maintenance visit.
Full system diagnosis
We test voltage and amp draw with a multimeter and clamp meter, read refrigerant pressures with a manifold gauge set, and check the capacitor, contactor, and thermostat operation. Diagnosis takes 30-60 minutes on most commercial units and identifies the actual failed component.
Refrigerant leak detection
If the system is low on charge, we use an electronic leak detector and nitrogen pressure testing to find the leak on the line set, evaporator coil, or condenser coil. We repair the leak, pull a vacuum with a vacuum pump, and weigh in the correct charge of R-410A or R-32.
Coil cleaning
Dirty condenser coils are the number one cause of high head pressure and compressor failure. We clean coils with a coil cleaning pump and fin comb, straightening bent fins and flushing away lint, grease, and debris. Clean coils cut energy use and extend compressor life.
Drain line clearing
A clogged drain line causes water leaks and a frozen evaporator coil. We clear the condensate drain, check the drain pan for cracks, and verify the trap is holding water. In restaurants and humid spaces we recommend a quarterly drain check to prevent overflow.
Electrical and control check
We tighten all electrical connections, test the capacitor and contactor, check the thermostat wire for damage, and verify the control board is sending the right signals. Loose connections cause voltage drop, which shortens the life of the compressor and blower motor.
Performance test and log
Before we leave, we run a full cooling cycle and check the temperature split across the evaporator coil. The target is 18-22 degrees. We verify the thermostat holds setpoint and give you a written summary of what we found, what we fixed, and what to watch.
Service overview
What commercial air conditioning services new york NY actually covers
Commercial air conditioning services new york NY is the licensed trade work that keeps business cooling systems running - repair, installation, maintenance, and emergency response for rooftop packaged units, split systems, ductless mini-splits, and VRF equipment. On a typical call we hook up a manifold gauge set, check refrigerant pressures against the data plate, test the capacitor and contactor with a clamp meter, and trace the thermostat wire back to the control board. If the compressor is pulling high amps or the condenser coil is packed with lint, we find it before we quote anything.
Most commercial AC repair near me new york NY calls in this city come down to a handful of failures: refrigerant leak, compressor failure, dirty condenser coils, frozen evaporator coil, clogged drain line, capacitor failure, blower motor failure, thermostat malfunction, or low airflow from a belt-driven unit. In restaurants along Steinway Street and offices in Midtown, the same pattern repeats - a unit runs nonstop, trips the breaker, and nobody notices until the dining room hits 88 degrees. We diagnose the actual cause, not the symptom.
The service timeline
How our commercial AC service call works
The process flexes to the condition, but these checkpoints keep decisions clear.
Phone triage
You call +18776434654 and describe the problem - no cooling, water on the floor, a unit that will not start. We ask the unit type, age, and whether it is a rooftop or split system. You get a two-hour arrival window, not a four-hour maybe. For after-hours emergencies we dispatch the on-call tech.
On-site diagnosis
The tech arrives, checks in with your manager, and heads to the unit. We use a multimeter and clamp meter to test voltage and amp draw, a manifold gauge set to read pressures, and a leak detector or inspection camera when we suspect a refrigerant leak or a cracked drain pan. Diagnosis takes 30-60 minutes on most commercial units.
Written quote before work
You get a written price before we touch a wrench. If it is a capacitor or contactor, the number is small and we can often fix it on the spot. If the compressor is grounded or the evaporator coil is leaking, we quote the replacement and explain the options in plain language. No surprise charges when the invoice arrives.
Repair or install
We complete the repair using OEM-grade parts - Carrier, Trane, Lennox, York, Rheem, Goodman, Daikin, Mitsubishi Electric, LG, Samsung, American Standard, and Bryant equipment. For a compressor swap or a full commercial air conditioning installation new york NY, we recover refrigerant with a recovery machine, braze new line sets with a torch kit, pull a vacuum with a vacuum pump, and weigh in the correct charge of R-410A or R-32.
Test and handoff
Before we leave, we run the unit through a full cooling cycle, check the temperature split across the evaporator coil (18-22 degrees is the target), verify the condensate drain flows freely, and confirm the thermostat holds setpoint. You get a summary of what we found, what we fixed, and what to watch. If it is a maintenance visit, you get the service log for your records.
Tools & methods
Tools and methods we use on commercial AC
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Manifold gauge set
Reads high-side and low-side refrigerant pressures to diagnose charge level, restrictions, and compressor performance. We compare readings to the data plate to confirm the system is operating within spec.
Vacuum pump
Pulls a deep vacuum on the line set after a repair or installation. A proper vacuum removes moisture and non-condensables that would otherwise damage the compressor and cause acid formation.
Refrigerant recovery machine
Recovers refrigerant into a recovery cylinder before we open the system. Required by EPA Section 608 rules. We recover R-410A, R-32, and legacy R-22 without venting to atmosphere.
Clamp meter and multimeter
Tests voltage and amp draw on the compressor, blower motor, and condenser fan motor. High amp draw points to a failing motor or a bad capacitor. We verify the repair by re-testing under load.
Leak detector
Electronic leak detection finds refrigerant leaks on line sets, evaporator coils, and condenser coils. We confirm with nitrogen pressure testing before repairing.
Coil cleaning pump and fin comb
Cleans condenser and evaporator coils and straightens bent fins. Dirty coils raise head pressure and cut capacity. Clean coils restore airflow and efficiency.
Inspection camera
Inspects ductwork, drain pans, and mechanical spaces you cannot see directly. We use it to confirm a cracked drain pan or a blocked duct before quoting the repair.
Use cases
When to call for commercial AC service
These examples show how the service framework adapts rather than forcing every call through one repair.

Office VRF system restored to full capacity
A 4,000-square-foot office in Midtown had a Daikin VRF system that was not reaching setpoint on the east side of the floor. The space stayed at 78 degrees while the west side cooled to 72. The property manager had received complaints from two tenants. → We tested refrigerant pressures and found a slow leak at an evaporator coil connection. We repaired the leak, replaced the filter drier, pulled a vacuum with a vacuum pump, and weighed in the correct charge of R-410A. The east side reached 72 degrees within 30 minutes of restart.
Retail shop stops losing customers to heat
A retail shop in Flushing had a rooftop unit that ran constantly but never cooled the sales floor below 80 degrees. The owner was losing customers who walked in and walked right back out. Two previous techs had added refrigerant without finding the leak. → We used an electronic leak detector and found a leak at the evaporator coil. We repaired the coil, replaced the filter drier, pulled a vacuum, and weighed in the correct charge. The unit reached 72 degrees in 20 minutes and the compressor amp draw dropped into the normal range.
Problems we solve
Commercial AC problems we fix in new york
Most commercial no-cool calls come down to a handful of failures. Here is what we see most often and how we fix it.
AC not cooling and the space is overheating
We diagnose the cause - low refrigerant charge, failed capacitor, dirty condenser coil, or a grounded compressor. Most no-cool calls are fixed in one visit with parts from the truck. If the compressor is bad, we quote the replacement and explain the options.
Water leaking from the unit onto the floor
A clogged drain line or cracked drain pan is usually the cause. We clear the drain, check the pan, and verify the trap. If the pan is cracked, we replace it. We also show your staff how to check the drain monthly to prevent a repeat.
Unit runs but trips the breaker
We test amp draw with a clamp meter and check the capacitor, contactor, and wiring. A weak capacitor or a loose connection is often the culprit. We replace the failed part, tighten connections, and verify the unit runs within the data plate amp range.
Frozen evaporator coil and low airflow
Low refrigerant charge or a dirty air filter causes most freeze-ups. We find the leak, repair it, recharge the system, and replace the filter. If the blower motor is failing, we replace it and verify the correct airflow across the coil.
Pricing process
What commercial AC service costs
$180 - $3,500 depending on scope
Unit type and tonnage
A 5-ton rooftop packaged unit takes less time to service than a 20-ton unit with multiple compressors. Larger units use more refrigerant, heavier components, and longer labor times. We quote based on the actual equipment data plate, not a flat rate that ignores size.
Roof access and rigging
If the unit is on a roof with easy ladder access, the labor is straightforward. If we need a hoist or crane to remove a compressor or condenser coil, that adds cost. We tell you before the work starts so there are no surprises.
Refrigerant type and charge
R-410A and R-32 are common and priced predictably. Legacy R-22 is expensive because it is no longer produced. If your system uses R-22 and has a major leak, we will show you the math on repair versus replacement.
Customer reviews
What commercial clients say
“Our rooftop unit died on a Friday night in July and the dining room hit 90 degrees. We called at 7 a.m. Saturday and a tech was on the roof by 9. He found a failed capacitor and a dirty condenser coil, had the part on the truck, and we were cooling again by 11. The invoice matched the quote. That is all I ask for.”
“We manage six commercial buildings in Queens and use them for all our HVAC work. They handle the maintenance contracts on the rooftop units and respond fast when a tenant calls about no cooling. Last month they replaced a compressor in a ground-floor retail space in one day. Clean work, no callbacks.”
“Our server room AC started leaking water onto the floor on a Tuesday morning. They sent a tech within two hours, cleared the clogged drain line, and replaced a cracked drain pan. He also showed me how to check the drain monthly so it does not happen again. Professional and straight with the pricing.”
Do you offer commercial AC repair in new york NY?
Yes. We run commercial AC repair new york NY calls for offices, restaurants, retail shops, warehouses, and mixed-use buildings across all five boroughs. Same-day service is available for no-cool emergencies, and we stock common parts like capacitors, contactors, and blower motors on the truck. Call +18776434654 and you get a two-hour arrival window. Most repairs are completed in a single visit.
How much does commercial AC maintenance cost in new york NY?
Typical 2026 pricing for commercial AC maintenance new york NY runs $180 to $450 per unit for a standard seasonal visit, depending on unit size and roof access. A commercial HVAC maintenance contract new york NY covering two visits per year usually lands between $350 and $850 per unit. Restaurant and retail units with heavy lint load may need quarterly coil cleaning, which is priced separately. You get a written quote before we start.
Do you offer emergency commercial AC repair in new york NY?
Yes. Emergency commercial AC repair new york NY is available after hours and on weekends. We dispatch the on-call tech and aim to be on site within 90 minutes for most Queens County and Brooklyn addresses. There is an after-hours dispatch fee, quoted upfront when you call. If your server room, restaurant, or retail floor is overheating, call +18776434654 and we will get a tech moving.
What types of commercial AC systems do you service in new york NY?
We service rooftop packaged units, split systems, ductless mini-splits, VRF systems, and make-up air units. Brands include Carrier, Trane, Lennox, York, Rheem, Goodman, Daikin, Mitsubishi Electric, LG, Samsung, American Standard, and Bryant. We handle refrigerant leak repair, compressor replacement, blower motor failure, thermostat malfunction, and electrical shorts. If your unit is not cooling, we diagnose the actual cause before quoting a fix.
Ready when you are
Get commercial air conditioning services new york NY today
If your business is overheating, call +18776434654. We run same-day commercial AC repair across Queens County and the five boroughs, with two-hour arrival windows and upfront pricing. EPA Section 608 certified, NYC DOB licensed, and insured.

Talk with the local team
Request Commercial Air Conditioning Services
Call us any time, day or night, and a real person picks up. We book same-day slots for most calls and text you the tech's name and arrival window. If you prefer email, send us your address and a quick description of the problem, and we will get back to you within the hour during business hours.




